Mike's 1993 Dodge Cummins Truck Blog

The fuel screw gets removed, a new oring added, and then reinstalled in this step.

Yet another warranty cover. This time it’s over the fuel delivery screw. More fun!!

I used the Xcelite 1/8″ screw driver to pry out on this cover. It finally took the large dikes to cut it off. There is an oring and a crimp on the shaft.

The shaft is left damaged from the crimp being on here so tight. Jim Lane at Dieseltruckresource.com wondered why these screws were damaged like this. Here is why.

Here is the tab that shows this pump is dead stock. The nut was very tight. When I got it off with an impact, the tab sheared off.

This screw is super important to get back into position. .716″.

This is how I actually took the measurement.

Here is the screw removed. I used tape to keep the threads from messing up the oring. Soda or shake straws cut to length work great too.

Oring in home position without a scratch. Remove the tape. Reinstall the fuel screw, set it’s height, and tighten the jam nut.

This is a warranty cover for the throttle arm limit screw.

It has to come off.

It finally took using some large dikes to cut the cover off. It had a nut inside of it that I turn the cover back and forth to get it off.

Got the nut out.

Must measure the adjustment screw so it goes back to the exact same position when I’m done. .486″ is the measurement.

Here is how I actually took the measurement.

Here is the reason all of this work had to be done. Access to this allen screw was not good enough since the screws are so tight on the pump.

All better now. Time to clean all around the perimeter before removing the top porting of the pump.

Once the 4 allen screws are out, here are the internals. That spring is the speed governor for the Cummins diesel engine. Stock it’s set to 2800-2900 rpm. This spring is labeled 366 which is for 3200 rpm. Someone added it before I owned it. Didn’t notice it would rev that high as I don’t push the truck at all.

Just remove one end of the spring from the upper part of the pump and set it aside. The spring and top hat assembly can be lifted straight up and removed.

First remove the bracket above the throttle assembly.

Removing the throttle shaft nut with an allen and then the throttle arms.

It’s hard to tell but there are 2 washers around the throttle shaft. The large rust colored one and the smaller on in the center with specs of white on it.

When you remove the washers this is what you see. The throttle shaft indexing. I made a mark on the shaft opposite the index mark that is all by itself. Click on this pic to see the larger image.

Here is the throttle shaft return spring right under the throttle arms.

Here the spring sits with the arms removed.

Here is a better shot of the spring and it’s upper and lower seats removed from the throttle shaft.

The throttle shaft is at the top of the pic. Pull it out.

The throttle shaft pushes right up and out of the upper half of the pump. I can’t seem to find the right oring for it so I grabbed one from my air conditioning assortment. I will use a Bosch oring instead. I just have to wait a day for the parts.

I ordered a new throttle shaft oring and removed my A/C oring by pinching it. It sticks up far enough to be grabbed and removed without any chance of scratching the shaft. Do this technique whenever possible. Make sure the thrust washer is still on the shaft when the final oring is installed.

Using tape to cover the threads and especially the index splines, keeps from gouging the oring during install. Use STP on the oring during install!!!! Insert the shaft back into it’s bore. Don’t add the throttle arms until the Final Assembly.