Although this Renix XJ runs pretty good, I thought it was time to put the MT2500 scanner on this rig. I’m concerned that the Map Sensor voltage is low at 1.0 volts. The Long Term Fuel Trims are way too low !! So the fuel system is trying to run the system leaner to make up for something else. Probably the Map Sensor. We shall see !!!
The tires of a vehicle act like an amplifier. Any noise, roughness, or slop in the bearings or suspension components cause slight vibrations that are magnified by the tire, causing Death Wobble. I’ve corrected Death Wobble on Jeeps, motorcycles, and model helicopters.
Finding the source of a Death Wobble isn’t that hard. Find the bad/sloppy parts and replace them. This is much cheaper than guessing !!!! This tie rod end mounted to the pitman arm had some movement in it when the steering wheel was rocked 90 degrees in both directions.The steering damper was ruined. The new part for it is on it’s way!!
The front face plate leaks freon. So does the main seal. Found these leaks with my freon sniffer. Also picked up a couple of junkyard compressors for parts For the Dodge as well.
The propane bottle has been sitting outside for years with the valves open to vent the gas and the smell. My freon sniffer and my nose can’t pick up anything. Once we test the socket and take the valve out of the bottle I’m converting, I’ll rinse it out with soap, water, bleach, and maybe even solvent. Then pull a vacuum on it.
The clutch is working smoothly. But the throw is a bit short. I’m working on the pedal linkage now. I’ll pick up a clutch master soon and put it in. Both of those repairs should fix it.